Under Construction
INSTALLATION:
Place case (A) against bottom board and push down (may be tight) until flush with bottom board. Attach case (A) with screws (I) pressing down on case to keep the case flush with bottom board (*bees will use gaps) (Fig. 1)
To remove case, loosen screws, lift and pull. (Fig. 2)
ENTRANCE REDUCER/SOLID:
Add reducer (E or F) to drawer. Add solid insert (D) to other drawer. Push drawers in completely and lock.
To add food/pollen substitutes or medications, place them into drawer with solid insert (D).
CLOSED:
Add solid inserts (D) to both drawers. Push drawers in completely and lock.
VECTORING:
Add powder to drawer as directed on package.
Snap block (G) into place above powder.
Add cone insert (C) (pointed inward) to powder drawer and cone insert (C) (pointed outward ) to other side. Push drawers in completely and lock.
REDUCING TRAFFIC:
To temporarily reduce outbound traffic, turn cone insert (C) pointed inward for both drawers. Push drawers in completely.
HIVE BEETLE DRAWER MONITOR:
Currently experimental: mix ¼ tsp apple cider vinegar with ¼ tsp hardened vegetable oil and spread on base of hive beetle drawer (H). Check periodically for presence of hive beetles.
*THIS IS NOT FOR VARROA MITE MONITORING
LOCK DRAWERS:
Lock drawers by aligning the holes of each drawer (J) with the hole of the case (K). Suggestions for the locking point are clevis fastener or cotter pins, twist tie, bolt, zip tie, etc.
OPTIONALS EXTRAS:
SwarmStopper™:
To temporarily prevent swarming, add SwarmStopper™ inserts (L - not included) to both drawers. Lock drawers.
*use no more than 2 consecutive days
VENTED INSERT:
The vented insert (M) can be used for moving hives or increasing ventilation with entrance reducer (insert E or F) installed.Add the vented insert (M) to drawer(s). For hive moving ensure you have locked the drawers and secured the ProtectaBEE™.
